Skip to main content
Print

WildTap Conditions of Use

  • The WildTap & Adaptor are not designed as replacement lid pieces for the Pro Quip Water Can during storage or travel.
  • The Wildtap & Adaptor can be installed onto a Pro Quip Water Can when intended for use and should be removed afterwards.
  • Always store in a cool area away from direct sunlight.
  • Ensure silicone hose is dry prior to storage.
  • Do not operate tap without water
  • Do not immerse tap in water
  • Do not operate with hot water, alcohol, oil or other corrosive liquids
  • Do not leave the WildTap installed on a moving vehicle/camper/trailer

BEFORE FIRST USE

  • Charge WildTap using included USB charging cable for 3 hours or until LED on top stays constant Red.
  • This product is suitable for charging with Android USB power supplies.

CHARGING

  • Charge using supplied USB charging cable
  • LED will flash Red when charging
  • LED will remain constant Red when it is fully charged
  • Charge time: 3 hours

OPERATION

  • On/Off button will commence and stop flow of water. LED will show constant white light during flow. Flow will automatically stop after 90 seconds to prevent accidental overflow or battery drain.
  • 600ml dispense button will commence a timed pour to dispense 600ml of water. LED will flash white light during flow. To stop the 600ml timed flow early, press the 600ml button again.
  • WildTap will dispense approximately 60litres between each charge (roughly 3 full Water Cans).
  • When charge is too low, WildTap will cease to operate and recharging is required.

MATERIAL SPEC

  • WildTap materials: BPA free, food grade silicone hose, 304 Stainless steel, high density ABS plastic shell. Adaptor Material: PETG-CF.
  • In-built 1200mAh lithium battery.
  • Working Voltage: 5V/1A.
  • Power: 4W.

ASSEMBLY

  1. Screw the Adaptor on to the opening of your Pro Quip 22L or 11L Wide Mouth Plastic Water Can.
    Please Note: The black arrow needs to points to the bottom of the 22L can and point to the top on the 11L can, screw on until the adapter is firm.
    (DO NOT FORCE OR OVER-TIGHTEN).
  2. Push the silicone tube over the Tap Inlet on the underside of the WildTap.
  3. Insert the free end of the silicone tube through the hole in the Adaptor.
  4. Locate the WildTap onto the Adaptor, ensuring the ridges on both line up correctly and gently press (and wiggle) so the WildTap seats itself firmly on the Adaptor.

To remove WildTap after use, grasp the base of the WildTap and gently wiggle and lift upward. The Adaptor can then be unscrewed from the neck of the Can.

Shopping Cart
Scroll to Top